MH 25V Analog Voltage Sensor Module


This is a sensor you can use with Arduino to measure varying voltage up to 25V.

5 in stock

Add to Wishlist
Add to Wishlist
SKU: MDU-SEN-MH-25V Category: Tags: , ,


MH Sensor Series

This is an easy to use sensor module you can use to sense varying voltage, but only for positive voltage. This module can help you to turn down a range of input voltage from 0 – 25V to 0 – 5V via a resistive voltage divider network. It comes with a screw terminal to connect the module to your load circuit so you can connect it easily without the need of soldering (depend on your load circuit).

Note : this sensor only works in analog mode. You can connect the analog output (AO) pin to Arduino to read voltage directly from the module. If you use this module on 3.3V devices such as ESP8266, you can only measure up to 16.5V maximum, more than this voltage will probably damage your device. NEVER use this to measure negative voltage or positive voltage of more than 25V!


  • Use 30K and 7.5K resistors for low resistive power loss
  • Output type : Analog
  • Operating voltage : 3.3 – 5V
  • Voltage range (at 5V) : 0 – 25V
  • Voltage range (at 3.3V) : 0 – 16.5V
  • Dimension : 28 x 12 x 10 mm



Label Meaning Connection
+ Power source Connect to 5V of system
Ground Connect to GND of system
S Analog Output Connect to analog input pin


Files & Documentation

Additional information

Weight 5 g
Dimensions 28 × 12 × 10 mm