JDY-31 SPP Bluetooth Wireless Transceiver Module

RM10.90

This bluetooth module is a working alternative for HC-05 or HC-06 at affordable price!

28 in stock

SKU: CNT-JDY31 Category: Tags: , , , ,

Description

This bluetooth module is a working alternative for HC-05 or HC-06 at affordable price!

This module utilizes UART serial interface protocol, so it can support SPP bluetooth serial protocol. It is designed to be low-cost, small, low power consumption but has high sensitivity in receiving signals.

Features

  • Use Bluetooth version 2.1 + EDR
  • Bluetooth Class 2
  • Built-in PCB transceiving antenna
  • Supports UART interface
  • Operating at 3.3V

Specifications

Operating Frequency Band 2.4 – 2.48 GHz unlicensed ISM band
Bluetooth Specification V2.1 + EDR
Output Power Class Class 2
Operating Voltage 3.3V
Host Interface UART
Operating Temperature -40 to +150ºC
Supply Voltage for VCC pin 5.6V (max)
Operating Baud Rate 38400/115200 bps

Notes

Only apply for RX pin on the bluetooth module, Arduino boards such as Uno, Nano and Mega board or other microcontrollers output 5V at their I/O pins. You need to use a voltage divider (1K + 2K resistor network) or logic level shifter to step down the 5V signal from microcontroller to 3.3V before feed it into RX pin on bluetooth module. TX pin on the bluetooth module outputs 3.3V signal and Arduino can perceive this voltage as HIGH, so stepping up this signal voltage is not required.

Additional Information
TXD : Transmitter pin, this pin must connect to RX pin of next device
RXD: Receiver pin, this pin must connect to TX pin of next device

There are 6 pins on this module, namely EN, VCC, GND, TXD, RXD, STATE. When the module is paired connection to a device (such as mobile phone), STATE pin will output HIGH, otherwise it will output LOW signal.
The built-in LED on the module indicates the bluetooth connection,

LED Blink Status Meaning
Slowly Waiting for connection…
Always on Connected

Bluetooth signal strength can be significantly affected by the surrounding especially the conductivity of surfaces. Installing the bluetooth module within metal enclosures can severely affect the bluetooth signal. Avoid placing metallic object, surfaces or wire near the PCB antenna on the module. It can severely affect the module’s ability to receive signals.

Files & Information

Additional information

Weight 5 g

Reviews

There are no reviews yet.

Be the first to review “JDY-31 SPP Bluetooth Wireless Transceiver Module”

Your email address will not be published. Required fields are marked *