A4988 Stepper Motor Driver Adapter Breakout Base Module

RM5.50

Adapter board for A4988 or DRV8825

10 in stock

SKU: DRV-A4988-BB Category: Tags: , , ,

Description

This breakout module has all the necessary components needed to make use of the stepper motor driver A4988 or DRV8825 driver carrier modules. You can adjust the NO switches to change the microstepping setting, following the driver datasheets.

Feed motor power to the VIN (or 9V in older version) pin to power up the stepper motor.

Note : Please insert the A4988/DRV8255 driver following the pin labels on the breakout module, inserting the module in reverse orientation will damage the driver carrier module when powered up. For DRV8825 driver module only, the +5V pin will be FAULT pin from the driver carrier module, so don’t connect 5V logic power to the +5V pin on the breakout module, only GND is needed to make common ground.

Pinout Table

Pin Name Meaning
E Enable Input LOW to enable the stepper motor and apply holding torque; Input HIGH to disable stepper motor and free stepper from holding.
D Direction Direction pin, Input LOW or HIGH to change direction depend on the mechanism.
S Step Step pin, Input numbered pulses to move the stepper motor position in the set direction.
+5V Logic Power 5V Power for logic operations
GND Ground Power Ground
VIN Motor Power Power Input for stepper motor
NO Switches Microstepping Microstep settings for 1/4, 1/8, 1/16, etc,

Additional information

Weight 10 g

Reviews

There are no reviews yet.

Be the first to review “A4988 Stepper Motor Driver Adapter Breakout Base Module”

Your email address will not be published. Required fields are marked *